Setting archecker Configuration Parameters in AC

Home | Previous Page | Next Page Overview of the ON-Bar Backup and Restore System > Setting ON-Bar Configuration Parameters >

Setting archecker Configuration Parameters in AC_CONFIG

Because ON–Bar calls the archecker utility to verify backups, you must configure these archecker parameters before you can use the onbar -v option. For more information about using archecker, see Verifying Backups. The following table shows the archecker configuration parameters for verifying backups that you specify in the AC_CONFIG file.

Configuration Parameter	Purpose	IDS	XPS
AC_MSGPATH	Specifies the location of the archecker message log	X	X
AC_STORAGE	Specifies the location of the temporary files that archecker builds	X	X
	Specifies the he timeout value for the onbar and the archecker processes if one of them exits prematurely	X
AC_VERBOSE	Specifies either verbose or quiet mode for archecker messages	X	X