The following configuration parameters are valid in the archecker configuration file.
| Configuration Parameter | Purpose |
|---|---|
| AC_DEBUG | Prints debugging messages in the archecker message log |
| AC_IXBAR | Specifies the pathname to the IXBAR file |
|
AC_LTAPEBLOCK |
Specifies the ontape block size for reading logical logs. |
|
AC_LTAPEDEV (IDS ) |
Specifies the local device name used by ontape for reading logical logs. |
| AC_MSGPATH | Specifies the location of the archecker message log |
| AC_PAGESIZE (XPS) | Specifies the online page size used by the server (can be overridden by the -Z command line parameter) |
| AC_SCHEMA | Specifies the pathname to the archecker schema command file |
| AC_STORAGE | Specifies the location of the temporary files that archecker builds |
| AC_TAPEBLOCK | Specifies the tape block size in kilobytes. |
|
AC_TAPEDEV (IDS) |
Specifies the local device name used by the ontape utility |
| AC_VERBOSE | Specifies either verbose or terse mode for archecker messages |
| BAR_BSALIB_PATH | Identical to the BAR_BSALIB_PATH server configuration parameter.
For more information, see BAR_BSALIB_PATH. |
If you do not set the following archecker configuration parameters in the ac_config file, the default values for their corresponding ONCONFIG configuration parameters are used:
If the ONCONFIG environment variable is not set, then the default values listed in this section are used.