Starting a Replicate Set

Home | Previous Page | Next Page Setting Up and Managing Enterprise Replication > Managing Replication Servers and Replicates > Managing Replicate Sets >

Starting a Replicate Set

To change the state of all the replicates in the replicate set to active, use the cdr start replicateset command. For example, to start the replicate set sales_set, enter:

set sales_set

When you start a replicate set, you can choose to perform an initial data synchronization, as described in Initially Synchronizing Data Among Database Servers.

Warning:

Run the cdr start replicateset command on an idle system (when no transactions are occurring) or use the BEGIN WORK WITHOUT REPLICATION statement after you successfully start the replicate.

For more information, see cdr start replicateset and cdr start replicate.