Home |
Previous Page | Next Page Unloading Data from a Database > Unload Job Windows >
On
the Unload Job Select window, you can specify to write to the tape
until the end of the device with the Write/read to/from tape until end of device checkbox.
When a tape device is full, you are prompted to provide the next
tape, until the unload job is complete.
Important:
If you select this option, you must also select it when
loading from the Load Job window or specify the -Z option
from the command line; otherwise, the loaded and unloaded data might
be inconsistent.
If you check this checkbox, it supersedes any tape size information
you enter in the device-array Definition window or at the command
line.
Important:
You must provide the same tapes in the same order on the
same devices for both the unload and the load jobs to ensure consistency.
Home |
[ Top of Page | Previous Page | Next Page | Contents |
Index ]