- Choose Jobs > Load from the HPL main
window.
The Load Job Select window appears, as Figure 108 shows.
- Click Create in the Selection Type group.
- Select a name for the job and type it in the Job Name text box.
- Optionally check the Write/read to/from tape until end of device check box. For more information, see Specifying to Read to the End of the Tape.
- Click OK.
The Load Job window appears, as Figure 109 shows.
- Type the appropriate values for the components of the load.
Icon Buttons describes the icons that represent the components of the load. For detailed information about these components, see the individual chapters on device arrays, formats, filters, and maps.
-
Select a base name for the files that
contain rejected records and type it in the Discard Records text
box.
Reviewing Records That the Conversion Rejected gives information about rejected records.
- Choose a name for the file that contains the load job status
log and type it in the Logfile text box.
For more information about the log file, see Viewing the Status of a Load Job or Unload Job.
- Click Options to change the load options.
For more information on these options, see Changing the Load Options.
- Click Save to save this load job. (If you click Run to run the job immediately, the job is saved automatically.)
- Now you can either run the load job or exit and run the job
later.
- Click Run to run the job.
- Click Cancel to exit to the Load Job Select window.
