Informix Error -43080: Process <process-id> received signal <signal-number>. </signal-number></process-id> Process will exit after cleanup.
Cause and resolution
Process <process-id> received signal <signal-number>. </signal-number></process-id> Process will exit after cleanup.
An ON-Bar process received a signal. Someone might have intentionally terminated the ON-Bar process with signal 2 (SIGINT), 3 (SIGQUIT), 9 (SIGKILL), or 15 (SIGTERM). ON-Bar is attempting to exit gracefully.
If the signal that terminated the ON-Bar process is not one of the signals listed above, contact IBM Informix Technical Support.
Oninit® Troubleshooting Guidance
Reasons / Common Causes
-43080 fires when an ON-Bar process receives a signal — per the official guidance, this is
usually an intentional termination signal (SIGINT, SIGQUIT, SIGKILL, or SIGTERM),
and ON-Bar attempts to exit gracefully.
- The ON-Bar process receiving signal 2 (
SIGINT), 3 (SIGQUIT), 9 (SIGKILL), or 15 (SIGTERM), per the official guidance — the expected case, usually an intentional termination. - The process receiving a different, unlisted signal, per the official guidance — the unexpected case.
Solutions / Resolution
- For one of the four listed signals, no action is required, per the official guidance — ON-Bar is exiting gracefully as intended.
- For any other signal, contact IBM Informix Technical Support, per the official guidance.
Examples
N/A
No specific triggering statement is documented beyond a process receiving a signal; the process ID and signal number are embedded in the message.
Diagnostic Checks
- Check the reported signal number against
SIGINT(2)/SIGQUIT(3)/SIGKILL(9)/SIGTERM(15), and escalate if it's a different signal.
Related Errors / Related Topics
No closely related error codes are cross-referenced for -43080 in this set yet.
An ON-Bar process received a signal and is exiting — normal for SIGINT/SIGQUIT/
SIGKILL/SIGTERM; escalate for any other signal.