Using the onpload Utility

In most cases, use the Load Job window (page Figure 109) or Unload Job window (page Figure 104) to prepare the load or unload job. After you prepare the job, the Command Line text box on the Load Job Select window (page Figure 108) or the Unload Job Select window (page Figure 103) shows you the command line that ipload prepared for the job. You can copy that command line and use it to run the job at a later time. You can also use the command-line options shown in this chapter to modify the basic command line that ipload prepared.

The following sections give additional information about the syntax and individual options of the onpload utility.