Translating with DrWatson… this can take a few seconds the first time.
This is a genuine, complex translation. DrWatson protects commands, error codes, and log output while naturally translating the surrounding text. It’s translated once and saved.
Finally figured this one out last week. Updating the group in case
anyone else comes across this issue. a new bug number has been created
BUG # 171453 and the issue is being looked into. this bug has to do
with how the job is created when you use hpl ( i recreated the problem
using the gui as well as onpladm). the default should be delimited but
for some reason unless you specify delimited by using the -zD option
and you are trying to load data into a table with a serial field bad
things happen. the data in the serial field will be way off and i found
not all of my rows were even loaded. basically the work around is
simple just add the -zD to the job creation and the data loads
correctly which consequently fixes the above problem with the engine
crashing.. etc.
i hate when people post a problem, no one ever posts a reply to it, and
the problem was most likely resolved with tech support or whatever and
then there is never anything updated on the original post, so i'll not
be one of those people. so if your actually looking for this problem
because your experiencing it and came across this post, i hope this
will help you.
good luck,
~Tisha
We use strictly necessary cookies to make this site work. With your
consent we’d also use optional cookies for analytics and marketing. You can accept all,
reject all, or choose. Read our Cookie Policy.