Re: Onconfig file parameters
An even better way to determine whether bor not your need to make the change
is to select * from sysconfig where cf_name = "parameter". This shows
original, effective, and default values for the parameter concerned. But
remember that the onconfig parameter is in upper case.
regards
Malcolm
----- Original Message -----
From: "Mark Denham" <mkdenham@comcast.net>
To: "Harki Rehal" <hrehal@yahoo.com>
Cc: "ilist" <informix-list@iiug.org>
Sent: Sunday, August 10, 2003 6:07 PM
Subject: Re: Onconfig file parameters
> The answer is, some are static and some are dynamic. If memory serves me
> correctly, you can get a good idea which ones are static by running
> onmonitor. Changes to the config here will trigger the utility to ask if
you
> want to shutdown to make changes effective.
>
> I have never seen anywhere that documents the static/dynamic
characteristics
> of the parameters.
>
> Mark
>
> ----- Original Message -----
> From: "Harki Rehal" <hrehal@yahoo.com>
> To: <informix-list@iiug.org>
> Sent: Sunday, August 10, 2003 11:25
> Subject: Onconfig file parameters
>
>
> > Do changes to config parameters in the onconfig file require reboots ?
> The
> > manual does not state which parameters are static ( no restart of
> informix)
> > and which parameters are dynamic ?
> >
> > For example what do I make of this description in the Administrators
> Manual:
> >
> > If you use the ontape utility, use the following parameters to describe
> your
> >
> > tape devices.
> >
> > Configuration
> >
> > Parameter Description
> >
> > TAPEDEV Specifies tape devices.
> >
> > TAPEBLK Specifies the block size of the tape device.
> >
> > TAPESIZE Specifies the maximum amount of data that should be written to
> >
> > each tape.
> >
> > LTAPEDEV Specifies tape devices.
> >
> > LTAPEBLK Specifies the block size of the tape device.
> >
> > LTAPESIZE Specifies the maximum amount of data that should be written to
> >
> > each tape.
> >
> >
> >
>
> sending to informix-list
sending to informix-list