Clarification on ONBAR restore sequence..

Hi I would like to clarify regarding the ONBAR restore. I want to perform an alternate client restore.The backups are serial whole system backup using "onbar -b -w -L 0".I have the ixbar file which contains only the recent level-0 entries. Assuming that the RESTARTABLE_RESTORE is enabled, i perform the physical restore with "onbar -r -p -w" and the database comes to "Fast recovery mode". At this point, i wanted to restore a subsequent level-1. So i will be either replacing the ixbar.0 file with another ixbar that contains level 1 entries or an ixbar which contains both the already restored level-0 and the new level 1 entries. I now start again the restore "onbar -r -p -w" since there is no specific command to restore only level 1. The whole issue is that I can take the level 1 backup from the source system only towards the end time of level 0 restore on the alternate client. Hence I will not have the updated ixbar (level1) entries during the level0 restore. Hence i got to replace the ixbar and hoping to kick off only level 1. 1)Will ONBAR restore only the level 1 ? or Will it go back and restore level-0 followed by level-1 ? 2)Will it restore only level 1 if the newly replace ixbar file contains only the level1 entries ? Your suggestions/comments are greatly appreciated. Rajesh Rajasekaran Informix Database Administrator Forest Pharmaceuticals Inc. 314-493-7073 (Work) sending to informix-list