RE: IECC problems with IDS Workgroup on NT

> I believe this specific onbar problem was resolved as follows > (make backup copies of the DLLs in $INFORMIXDIR\\bin to be safe): > > To fix it, copy the following files from ISM\\1.0 to $INFORMIXDIR\\bin: > libnsr.dll > librap.dll > librpc.dll > liblocal.dll Hmm. > PS. I am using ontape instead of IECC/BAR Wizard since I > cannot get it > to work as I would expect. I am thinking of giving up on ISM altogether. It really doesn't work very well at all. Especially if you don't have access to a tape drive. > Alain Mouligeaux wrote: > > > > Hello, > > > > I have 2 major problems with IDS Workgroup (7.30.TC9) on NT: > > > > 1) IECC problem: > > on the server itself and also on one workstation, IECC gives the > > following message: "A problem with the connection to the > server has been > > detected"; > > However, on a second workstation installed with IECC, the > problem does > > not occur. Cannot help with this one. > > 2) Onbar problem: > > when starting the Onbar utility for a complete backup, I have the > > following message: "onbar-d.exe Entry point not found The Procedure > > Entry Point ca_hardlink_path_addr_func could not be located in the > > dynamic library LIBNSR.DLL" Had something similar and after finding all references to ISM\\1.00 in all batch files and anywhere else I could and change them to ISM\\2.20 it still failed :-(. Then I discovered a new entry in ONCONFIG called BAR_BSALIB_PATH H:\\ISM\\2.20\\bin\\libbsa.dll # Location of ISM XBSA DLL Once this was set all my problems went away. Well ok, I could now run ISM Hope this helps. Cheers David --------------------------------------------------------------------- This message has been Content Filtered by MailMarshal. ---------------------------------------------------------------------