Re: Informix KAIO on SCO 5.0.4

David Williams wrote: >In article <700oms$29h$1@nnrp1.dejanews.com>, jshaley@my-dejanews.com >writes >>Has anyone had luck enabling KAIO on a SCO 5.0.4 server? >>I am using IDS 7.23.UC6, and per the release notes, installed the SCO >>aio and suds drivers. >> >>When I brought up IDS with KAIOON=1, again as per the release notes, online >>crashed with an errno=14. Some root pages were corrupted and I had to do >>a cold restore from archive! Luckily it was a development system, so only >>the programmers were screaming. >> >>Informix tech support found a few similar cases, all ending with "call >>SCO". They suggested raising the kernel parameters - NAIOREQ and NAIOBUFF - >>from 200 to 400. The downside of getting this wrong seems >>a bit extreme, so I'm about to say KAIO is not really available on SCO. >> I added the AIO support to kernel (mkdev aio) and I configured the SUDS package. As was stated in a previous message I have run suds_ctrl -a informix After this I have set the KAIOON=1 and have start the Informix Server (DSA 7.3UC2). And all is working for me. Best Regards, Octav > > What version of 5.0.4. I think I'm running 5.0.4e. When you install > remember to add the SUDS(?) package. It's the extra package to support > databases e.g. Informix.. > -- Octav Chiriac Phone: (373) 2 21 20 96 NetInfo S.R.L. Fax: (373) 2 21 36 59 Chisinau (373) 2 24 00 83 Moldova, Republic of mailto:com@netinfo-moldova.com