Re: Urgent replication problem

Bjorn, 9.21TC3 is a fairly old release at this point. Have you considered migrating to a more current release level? I know that 9.4 received quite a few HDR fixes. "Bjorn De Waele" <bjornREMTHIS@pandora.Be> wrote in message news:C0PUc.218383$BL6.10847290@phobos.telenet-ops.be... > Hello everybody, > > > today we brought our dbase down to finetune our onconfig. After it, it > couldn't get started anymore. So we placed our old onconfig back. > > Everything was fine again except that our secondary stayed in fast recovery > mode. It was very long so we supposed that our replication was corrupt. No > problem, we made a new ontape -s and set our replica up again. > But right now we still have the same problem .... Our replica stays in fast > recovery mode. We're running 9.21 TC3. > After 3 hours, it was still the same, no activity on the server. > > I did some tests with the onstat -p to check disk activity. I resetted the > activity with onstat -z before the replica thread started (onstat -g ath). > Once the replica started, my pagewrites went step by step to 84000 but there > it stands.... nothing happens anymore.... > > In onstat -d, I don't see down chunks. > Onstat -g ath gives me a cond wait for drcb_bqe in dr_secrcv > > I think the thread is waiting and waiting ... but I don't know for what ! > > I really hope someone could help me out or hint me cause we're running our > reports on that secondary. > > Thanks in advance ! > > Bjorn > >

Hello everybody, thanx a lot for your replies. I had contact with informix desk and they told me also that 9.21 isn't a recent release. We'll just try a reboot from our primary and if it still fails then, we'll go to 9.4. Bjorn "Madison Pruet" <mpruet@comcast.net> wrote in message news:5qmVc.291055$%_6.8255@attbi_s01... > Bjorn, > > 9.21TC3 is a fairly old release at this point. Have you considered > migrating to a more current release level? I know that 9.4 received quite > a > few HDR fixes. > > "Bjorn De Waele" <bjornREMTHIS@pandora.Be> wrote in message > news:C0PUc.218383$BL6.10847290@phobos.telenet-ops.be... >> Hello everybody, >> >> >> today we brought our dbase down to finetune our onconfig. After it, it >> couldn't get started anymore. So we placed our old onconfig back. >> >> Everything was fine again except that our secondary stayed in fast > recovery >> mode. It was very long so we supposed that our replication was corrupt. > No >> problem, we made a new ontape -s and set our replica up again. >> But right now we still have the same problem .... Our replica stays in > fast >> recovery mode. We're running 9.21 TC3. >> After 3 hours, it was still the same, no activity on the server. >> >> I did some tests with the onstat -p to check disk activity. I resetted > the >> activity with onstat -z before the replica thread started (onstat -g >> ath). >> Once the replica started, my pagewrites went step by step to 84000 but > there >> it stands.... nothing happens anymore.... >> >> In onstat -d, I don't see down chunks. >> Onstat -g ath gives me a cond wait for drcb_bqe in dr_secrcv >> >> I think the thread is waiting and waiting ... but I don't know for what ! >> >> I really hope someone could help me out or hint me cause we're running >> our >> reports on that secondary. >> >> Thanks in advance ! >> >> Bjorn >> >> > >