Re: Informix 6 and SCO 5
I suppose you have to add -lx to your cc options (and check out the position of this option among other libraries, if it is already in the command line try moving it to the end of -l options). Hope this helps, Octav On Thu, Oct 14, 1999 at 12:41:44PM -0400, Zimmerman, Justin (BCC Tech Support) wrote: > I have informix 6 SE for SCO 3.2.4.2 - I tried installing it on a SCO > OpenServer 5.04 system. The binaries (already compiled 4gl) seem to run just > fine. The i4gl environment also seem to work just fine. However I am having > a problem compiling. When i try to compile some 4gl code it makes it all the > way to phase 3 and then returns an undefined nap symbol error. > Does anyone know what compile flags to use (/etc/default/cc)? or how i can > go about solving this so that i can compile on OpenServer? > > Thanks > Please send all replies to jgzimmerman@exchange.ml.com > -- Octav Chiriac Phone: (373) 2 22 99 67 NetInfo S.R.L. Fax: (373) 2 21 36 59 Chisinau (373) 2 22 84 88 Moldova, Republic of mailto:com@netinfo-moldova.com
I believe the development system for SCO 3.2.4.2 was version 1.2. There were important changes in the development system with the introduction of SCO 5.0.x, but SCO maintained backward binary compatibility. Since Informix is specifically ported with the native development system, perhaps your problems are the result of these changes. You may need to upgrade your Informix license to the SCO 5.0.x platform. Octav Chiriac wrote: > I suppose you have to add -lx to your cc options (and check out > the position of this option among other libraries, if it is already > in the command line try moving it to the end of -l options). > > Hope this helps, > Octav > > On Thu, Oct 14, 1999 at 12:41:44PM -0400, Zimmerman, Justin (BCC Tech Support) wrote: > > I have informix 6 SE for SCO 3.2.4.2 - I tried installing it on a SCO > > OpenServer 5.04 system. The binaries (already compiled 4gl) seem to run just > > fine. The i4gl environment also seem to work just fine. However I am having > > a problem compiling. When i try to compile some 4gl code it makes it all the > > way to phase 3 and then returns an undefined nap symbol error. > > Does anyone know what compile flags to use (/etc/default/cc)? or how i can > > go about solving this so that i can compile on OpenServer? > > > > Thanks > > Please send all replies to jgzimmerman@exchange.ml.com > > > > -- > Octav Chiriac Phone: (373) 2 22 99 67 > NetInfo S.R.L. Fax: (373) 2 21 36 59 > Chisinau (373) 2 22 84 88 > Moldova, Republic of mailto:com@netinfo-moldova.com