Any Informix Schema Printing Utitlity ?

Posted in 2000

Summary

Francis asked whether a schema printing utility exists. Robert Stuart suggested running dbschema -d database into a file, or piping it to a print command, and noted the start-up lines it prints. The rest of the thread was a side discussion about newsgroup posts not appearing for some readers.

Auto-generated by Claude from the posts below — may be imperfect; read the full thread.

Topics: General Discussion

Francis — Wed, 6 Sep 2000 08:45:17 +0800 — source: Informix-list mailing list archive (1991-1998)

Anybody knows if there is a schema Printing Utility Pls let me know my email francis@jnesw.com.sg Thanks.

↪ replying to Francis

Robert Stuart — Wed, 6 Sep 2000 08:47:43 +0100 — source: Informix-list mailing list archive (1991-1998)

Have you tried dbschema -d database filenameThen just print filename. You could just pipe run dbschema -d database | print_commandBut you'll get 6 or 7 lines of start-up If you just run dbschema It'll give you all the runtime options "Francis" <francis@jnesw.com.sg> wrote in message news:8p44fp$rb2$1@violet.singnet.com.sg... > Anybody knows if there is a schema Printing Utility > Pls let me know my email francis@jnesw.com.sg > Thanks. > >

↪ replying to Robert Stuart

remove (_at_) to reply — Wed, 06 Sep 2000 10:25:32 +0200 — source: Informix-list mailing list archive (1991-1998)

When Francis wrote his message? I am not sure but I think that I have some problems with reading NG. I don't have for examlpe Francis's question and some other, too. Please answer me. Nebojsa On Wed, 6 Sep 2000 08:47:43 +0100, "Robert Stuart" <robert.stuart@nfer-nelson.co.uk> wrote: >Have you tried > dbschema -d database filename>Then just print filename. > >You could just pipe run > dbschema -d database | print_command>But you'll get 6 or 7 lines of start-up > >If you just run > > dbschema> >It'll give you all the runtime options > > > >"Francis" <francis@jnesw.com.sg> wrote in message >news:8p44fp$rb2$1@violet.singnet.com.sg... >> Anybody knows if there is a schema Printing Utility >> Pls let me know my email francis@jnesw.com.sg >> Thanks. >> >> >

↪ replying to remove (_at_) to reply

Robert Stuart — Wed, 6 Sep 2000 14:06:34 +0100 — source: Informix-list mailing list archive (1991-1998)

I included the full message last time around ... Several NG users have complained of similar problems (including myself). So the last three lines of your response were Francis's full question. "remove (_at_) to reply" <mips_at_@zg.tel.hr> wrote in message news:qmvbrscj555v1a537jc0llkau24lvevr09@4ax.com... > When Francis wrote his message? I am not sure but I think that I have some > problems with reading NG. I don't have for examlpe Francis's question and some > other, too. > > Please answer me. > > Nebojsa > [deleted - by RAS]