Archecker

Posted in 1999

Luse Harold — Wed, 3 Mar 1999 18:40:18 -0700 (MST) — source: Informix-list mailing list archive (1991-1998)

Does any one know the command to get archecker to verify a tape backup? I have messed with it a bit, but I can't seem to get it to run. ==================================================================== Harold Luse Phone: (970) 491-4120 Veterinary Teaching Hospital Fax: (970) 491-4123 Colorado State University Pager: (970) 229-8173 Fort Collins, Colorado USA E-mail: hluse@vth.colostate.edu ====================================================================

↪ replying to Luse Harold

Art S. Kagel — Thu, 04 Mar 1999 15:49:29 -0500 — source: Informix-list mailing list archive (1991-1998)

Luse Harold wrote: > > Does any one know the command to get archecker to verify a tape backup? > I have messed with it a bit, but I can't seem to get it to run. Instructions should be in the release notes. You have to set up the archecker config file which specifies drives and file locations as well as level of diagnostics and messages, then launch. Art S. Kagel

↪ replying to Art S. Kagel

Doug McAllister — Fri, 05 Mar 1999 14:39:52 -0500 — source: Informix-list mailing list archive (1991-1998)

According to the release notes from a 7.30.uc5 installation: > The archive checker tool for ontape and ON-Bar is not documented or > supported for customers. Only Informix technical support or consultants > can use it. > This quote is from the file SERVERS_7.3 in the $INFORMIXDIR/release/en_us/0333 directory. I would also like to be able to verify archives..... Doug McAllister "Art S. Kagel" wrote: > Luse Harold wrote: > > > > Does any one know the command to get archecker to verify a tape backup? > > I have messed with it a bit, but I can't seem to get it to run. > > Instructions should be in the release notes. You have to set up the > archecker config file which specifies drives and file locations as well > as level of diagnostics and messages, then launch. > > Art S. Kagel