Re: Archecker

Archecker is planned in the coming Centaur (formerly 7.3/9.2) release of IDS, and will be fully supported and documented. The beta program for that release begins in a few weeks. At 02:39 PM 05-03-99 -0500, Doug McAllister wrote: > >--------------DAE029BBFA4FFF7B15312A16 >Content-Type: text/plain; charset=us-ascii >Content-Transfer-Encoding: 7bit > >According to the release notes from a 7.30.uc5 installation: > >> The archive checker tool for ontape and ON-Bar is not documented or >> supported for customers. Only Informix technical support or consultants >> can use it. >> >This quote is from the file SERVERS_7.3 in the >$INFORMIXDIR/release/en_us/0333 directory. > >I would also like to be able to verify archives..... > >Doug McAllister > >"Art S. Kagel" wrote: > >> Luse Harold wrote: >> > >> > Does any one know the command to get archecker to verify a tape backup? >> > I have messed with it a bit, but I can't seem to get it to run. >> >> Instructions should be in the release notes. You have to set up the >> archecker config file which specifies drives and file locations as well >> as level of diagnostics and messages, then launch. >> >> Art S. Kagel > >--------------DAE029BBFA4FFF7B15312A16 >Content-Type: text/html; charset=us-ascii >Content-Transfer-Encoding: 7bit > ><!doctype html public "-//w3c//dtd html 4.0 transitional//en"> ><html> >According to the release notes from a 7.30.uc5 installation: ><blockquote TYPE=CITE> ><pre>&nbsp;The archive checker tool for ontape and ON-Bar is not documented or >&nbsp;supported for customers. Only Informix technical support or consultants >&nbsp;can use it. ></pre> ></blockquote> >This quote is from the file SERVERS_7.3 in the $INFORMIXDIR/release/en_us/0333 >directory. ><p>I would also like to be able to verify archives..... ><p>Doug McAllister ><p>"Art S. Kagel" wrote: ><blockquote TYPE=CITE>Luse Harold wrote: ><br>> ><br>> Does any one know the command to get archecker to verify a tape backup? ><br>> I have messed with it a bit, but I can't seem to get it to run. ><p>Instructions should be in the release notes.&nbsp; You have to set up >the ><br>archecker config file which specifies drives and file locations as >well ><br>as level of diagnostics and messages, then launch. ><p>Art S. Kagel</blockquote> ></html> > >--------------DAE029BBFA4FFF7B15312A16-- > > > _______________________________________________________________ Clem Akins (aka clem@informix.com) Menlo Park x5937 Customer Course Development Informix Software, Inc Last seen: Mt Tamalpais in Marin county, California USA